TRIARC Systems Easy Pin Gas Block for AR15 and AR10 Barrels .750 ID
$59.95
In stock
The TRIARC Easy Pin Gas Block’s design is specifically engineered to simplify the pinning process, which is traditionally one of the most difficult parts of an AR-15 or AR-10 barrels . The pre-cut hole means there is no wasted time by drilling through the gas block. This pre-cut hole is positioned low enough, so only the necessary amount of material from your barrel is removed to ensure a “bombproof” installation. Since there is less material to remove, pinning the barrel is easier to accomplish with a standard hand drill or drill press. We always recommend that a competent gunsmith do the installation. However, because of the gas block’s design, it is much easier for the individual builder to accomplish the pinning of the gas block without catastrophic damage to the barrel or gas block.
TRIARC Easy Pin Gas Block features:
– 4140 Carbon Steel Construction with Black Nitride Process
– Low Profile to Fit Inside All Handguards
– Counter Bore Pin holes
– Stainless Coil Roll Pins for Gas Block and Gas Tube
– Serrated Steel Locking Screws
– .750” Internal Diameter
– Pre-Cut for Easy Pinning
– Gas Efficiency Through Exacting Tolerances
Includes:
– Gas Block
– (2) Serrated Steel Locking Screws
– (1) 5/64 Stainless Steel Coiled Roll Pin
– (1) 1/8 Stainless Steel Coiled Roll Pin
Tools Needed:
– Drill Press or Hand Drill
– 1/8” drill bit
– Roll pin punch
– Hammer
MFG P/N# TEP-GB-N
TRIARC Easy-Pin Gas Block – Instructions
In stock