TRIARC Systems x THF Hybrid Mil-Spec BCG for AR15 5.56 / .300 BLK

$310.00

Out of stock

TRIARC Systems x TACHUNTFISH Hybrid Bolt Carrier Group

****Coating Notes*****

ArmorLube is a duplex coating that combines lubricity, chemical inertness, and corrosion resistance with the case-hardening properties of plasma nitride. This coating delivers hardness and durability for extreme applications.

NP3® metal finish offers many benefits. NP3® permits firing for longer periods between cleaning, dirt, and powder residue have no wet or oily surface to cling to. When cleaning is required, the effort needed is minimal – usually requiring only a soft cloth. NP3® is corrosion-resistant and it provides a high lubricity and low friction coefficient, greatly increasing the life expectancy of a firearm due to reduced friction wear. NP3® is a satin gray, non-reflective color ideal for all firearms.

 

    • Increases reliability
    • It requires little to no oil for lubrication, although we recommend using some oil during break-in.
    • Very accurate and even coatings on all activated surfaces.
    • Permits firing for longer periods between cleaning, as dirt and powder residue has no wet or oily surface to cling to.
    • NP3® has a microhardness of 48-51 Rockwell as plated (nickel matrix).
    • NP3® is very corrosion resistant, with a 1 mil (.001) coating exceeding a 250-hour salt spray test.
    • NP3® has high lubricity and low friction coefficient; therefore, the life expectancy of a firearm will be greatly increased due to reduced friction wear.
    • The coating is strippable with no effect on the base metal, allowing other coatings to be applied or a new coating of NP3® to be applied, if necessary.
    • NP3® plated onto stainless steel guns will prevent galling, a problem common with stainless steel.
    • NP3® is a satin gray, non-reflective color ideal for all firearms.
    • NP3® can be plated to all internal parts giving a smoothness to the action not found with any other coating.
    • In cases where the NP3® has been perforated, the corrosion shows no tendency to spread or migrate under the coating.
    • NP3® is guaranteed against corrosion, peeling, or flaking for the lifetime of the firearm.

TRIARC Systems x THF Hybrid BCG

FULL AUTO RATED

Bolt Carrier: Case Hardened 8620 steel and ArmorLube Coated

Gas Key: Attached with 4140 steel, NP3 Coated, re-embedded with Optimized Carrier Key Screws (O.C.K.S.), and properly staked.

Cam Pin: Hardened 4140, NP3 coated with direction orientation laser marking

Firing Pin: 17-4 Stainless Steel

Bolt Assembly: Machined from case hardened 9310 steel then shot-peened, heat treated & 100% MPI tested per US Mil-Spec, and NP3 Coated
*Properly heat treated 9310 steel is on average 8% stronger than Mil-Spec standard Carpenter 158 steel, making the bolt stronger than the Mil-Spec standard*

Extractor: Billet 4140

Extractor Spring: Upgaded Cryogenically treated 5 Coil Enhanced Extractor Spring from Sprinco USA to further  increased reliability

 

****** Each THF BCG is Test fired with 5.56 Ammunition ******

 

P/N: BCG-15-THF-HYBD

 

Out of stock

Join the waitlist to be emailed when this product becomes available